Nimrod LiPo Battery 11.1V 1800mAh Deans

Presentation

This Nimrod battery is a LiPo type and is composed of 3 cells that make up a compact assembly. It has a voltage of 11.1V and a capacity of 1800mAh. The battery's technology allows for very small dimensions of the entire assembly, enabling it to be installed in spaces intended for very small batteries. The discharge of the battery at 65C allows for an optimal current supply for the replica's current needs.

The battery's insulation is well made and the cables and connectors are of high quality. This battery is equipped with a small Tamiya plug.

ATTENTION:

• Lithium Polymer (LiPo) batteries can be extremely dangerous.
• Users must take all precautions for: potential fires, bodily harm, and damage to property.
• If used improperly, damaged, or have manufacturing defects, LiPo batteries can cause explosions, fires, smoke, and risk of intoxication.
• By purchasing this type of battery, the user assumes responsibility for any risks associated with LiPo batteries.
• LiPo batteries are not toys and should not be left within reach of children as they can pose a real danger to their health.
• LiPo batteries should not be thrown into fire, placed in an oven, or microwave as they can explode.
• LiPo batteries contain/emits electrolytes, toxic vapors, and other harmful chemicals. Handle these batteries with care and avoid, under any circumstances, contact with the skin, eyes, or other parts of the body. In case of contact, rinse thoroughly with water and seek medical attention immediately.
• Do not attempt to charge mechanically or chemically damaged batteries.

Actions that lead to battery damage

• Charging LiPo batteries with a non-balancing charger and without automatic charging cutoff.
• Connecting a cell or another battery in series or parallel even if they appear to be similar.
• Exceeding maximum and minimum operating voltages.
• A decrease or increase in temperature outside the permissible limits.
• Too high of a charging current.
• Short-circuiting the battery terminals.
• Subjecting the battery to mechanical shocks such as dropping, hitting, bending, cutting, twisting, deforming, or puncturing.
• Contact with liquids.
• Improvise an inappropriate charging installation.
• Using improper, improvised charging cables.

General Information

• LiPo batteries are made up of cells.
• The parameters of these types of batteries are: Voltage measured in Volts (V), Capacity measured in milliampere-hours (mAh), and instantaneous discharge (C).
• Each LiPo battery has a power plug and a charging plug connected to it.
• The power plug is used to power the device intended for power supply.
• The charging plug is exclusively used for charging the battery. (in some cases, both charging and power may occur through the power plug)
• The battery is charged using the charging plug, and in some advanced chargers, it is necessary to connect the power plug as well.
• LiPo batteries are charged with special chargers for LiPo batteries that have the function of balancing the voltage of each cell and automatic charge cutoff.
• Each LiPo battery has a maximum charging rate of 1.05X of the battery capacity, which must not be exceeded during charging.
• Each cell has a maximum voltage of 4.2V and a minimum voltage of 2.7V.
• During operation or charging, the battery temperature should not fall below 0°C or rise above 50°C.
• For long-term battery storage, the battery capacity should be between 15 and 25% of the maximum value.

NRG cannot guarantee that you have used correct methods of operation and have followed the charging, discharging, or storage conditions of LiPo batteries. For this reason, we reserve the right to refuse replacement as a warranty of inaccurately used batteries (those that violate the instructions and warnings above) and we are not responsible for material, moral damages, or loss of human life.